!#44# The choice of taps on the floor for a traditional-style roll Bath

!±8± The choice of taps on the floor for a traditional-style roll Bath

Traditional roll top baths are sometimes called, with the flattened edge of the hole. Taps can be mounted on the edge of a rolling roll top bath can be the bathroom tap hole on the tip of the mountain or the valves must be mounted on a wall, or be as an independent unit taps. This article examines some of the most important questions to consider when you choose a traditional style fittings of a bathtub role. This product is made with modern bathrooms and not interestedantique bathrooms.

The choice of tubes to be

Usually choosing a set of taps and fittings on the pipe. Although a couple of free-standing traditional taps are like a single part, this is usually not the case. Almost all bridge taps mounted (ie normal taps, bath fillers and bath shower mixers) can be connected to a standpipe (this does not mean that they are for use with your own bathroom - see below). The choice of stand pipes for contemporary accessories to avoid thistypically have a bracket made for a hand shower, where you do not agree with a traditional water pipe, which is an old-fashioned phone must have rest for the shower. Also not to be confused with the stand pipe shroud tube. Shroud tube (usually extension) are used for copper pipes running from the tap hole ground cover and had not robust enough for the weight of the cocks, standpipes hear the other side covers the tubes and support the weight of the cock. Usually, no tubes to benot through the pipeline to take water directly to the shroud, hiding the real water supply hose. Pipes to be varying amounts of times can be as high as 660 mm or 700 mm. In general, his sense of air tubes 660 mm for a bath, using up to 660 mm high from the floor to the top of the circle where the valves. The higher your stems are the most impressive touches.

The choice of a suitable valve

The bathroom taps traditional, full bath and shower mixers are not suitablestandpipes for use as a stand-alone unit taps. Even if you put the fork tubes, most of them do not have sufficient capacity for the power to get comfortable on the edge of the tub. In general, you need to know what elbow knocks his leg is called, has a bent leg, you tap an additional piece to the bottom of each leg with an extra wiggle the tap water is that it pushes up and forward to give who come to do more for well over the edge of the tub. In general, you must achieve a minimum of 150 mm (tubeCenter of outlet centers), you should always check before you make your taps and you should always make sure that you need not even enough for each one taps in the bathroom with the work to be carried out.

Summary

So the main questions are:

1 Get a pair of traditional fountains without shower holder

2 Measure the height of your bathroom (with legs, if they did) and go to the fountains right height with him.

3 Look for a technical drawing of the rooster, and one for the bathroomif you check and make sure you have enough power to get the tap water to get comfortable on the edge of the tub.